Support
Jumper Settings
ATAPI HD DVD-ROM Jumper Settings (Half-height drives only)
A block of mode select jumpers can be located on the rear of your HD DVD-ROM. If a jumper covers both pins on the jumper block, it is ON; if there is no jumper or only one of the pins is covered, the jumper is OFF.
- CS Drive is configured using host interface signal CSEL
- SL Configures drive as Slave
- MA Configures drive as Master (default mode)
In most installations, jumper should remain in the MA position (factory default). It is recommended that you install your drive only on the secondary IDE BUS. If you are installing on primary IDE BUS, your hard drive would then be the Master, and you should set your drive to the Slave position (SL)
Jumper location on ATAPI CD/CD-RW/DVD drives
(location may be different on some drives)
(location may be different on some drives)